Re: Gateway 2.0 web server issues

Posted by vysocan on
URL: http://ohs.356.s1.nabble.com/Gateway-2-0-web-server-issues-tp237p238.html

Hello Charles,

thanks again for your appreciation.

It might be that you wired the PIR sensor wrongly, and making short on 12V rail. To check that, just disconnect the sensor completely and connect just a piece of wire from zone 1 input to GND(-). Then see the web interface.

If you are making short one or two of the resetable fuses will be hot/warm. Zone fuse is bottom right, main is top left orange disc. This basically drain power from whole system. Do not run the system shorted for long time the fuses will definitely degrade if shorted for long time.

Other hints, see STATUS LED, blinks periodically if system is running. Also, you can plug in micro USB cable to gateway and open terminal and play with the commands while you see problem with web interface.

Also I have updated version, I would suggest to upload latest one. Latest compiled firmware is present here: https://github.com/vysocan/OHS_2-gateway/releases

Guide how to upload it: https://openhomesecurity.blogspot.com/2020/08/dfu-device-firmware-upgrade.html It might be you need to power off gateway after all is updated, as I have fixed the reset sequence for DFU just recently.

PIR sensors should be connected as balanced, with 2 resistors that should be included, see: https://openhomesecurity.blogspot.com/p/blog-page_16.html

But go with first step first, to test if you are not making short.

Adam